Recent content by damian1955

  1. D

    Stalls out hot

    It's getting too cold to test. I will disconnect the ESA and see what happens. It only does it at about 155 degrees and I smell fuel ?
  2. D

    Stalls out hot

    Choke works fine
  3. D

    Stalls out hot

    It calls for a 160 thermostat and it just gets close to that temp.u
  4. D

    Stalls out hot

    I will double check the temp of the installed thermostat. tks
  5. D

    Stalls out hot

    I can disconnect the ESA and try that. It's getting cold to play with this thing. Wind chill was 37 degrees this morning. Lol
  6. D

    Stalls out hot

    Choke works fine
  7. D

    Stalls out hot

    Water pump new last year. I can smell fuel when it bogs down and stalls.
  8. D

    Stalls out hot

    It does not have an over temp sensor. That was an option I don't have.at 150 degrees I can run wide open until it gets to about 165 and starts to bog down and stall. Will restart when gets around 125. Degrees
  9. D

    Stalls out hot

    New points, consider and coil. If I run it at half throttle the temperature stays around 150. It has a 180 thermostat in it which is newer. At 150 degrees I can run all day
  10. D

    Stalls out hot

    I have a 1987 Chris Craft I/O 2.3 litre ford engine. It runs fine before the temp reaches over 160 degrees. after that it will bog down and stall. It will restart after it cools down.It will run ok when I run it at about 1/3 throttle and stays cooler. I have replaced the points,condenser and...
  11. D

    1987 2.3l hard shift

    Can I remove the shift assist module if I keep the RPM's at 600 ?
Top