Recent content by damburg1

  1. D

    95 Evinrude 150 Rectifier install

    I have a 95 Evinrude 150 model J150GLEO. I needed a new rectifier so l ordered the OMC part #585219 since it was on the list of compatible parts. Upon installation attempt I noticed that the 585219 does not have a purple wire. It has red, two yellows going to the connector, and one grey wire...
  2. D

    1995 Evinrude Intruder 150 runs only with key in crank position

    My motor cranks and runs but only with the key in the crank position. I put a volt meter to the kill switch and got the following. Lanyard connected: (B/Y to Red wire) Key in off position - 12 volts, with key in run position 0 Volts. With Lanyard disconnect: Key in Off position 12 Volts, Key...
  3. D

    95 Evinrude Intruder 150 rough and low compression

    I recently purchased a boat with a 1995 Evinrude 150 model E150GLEOM. I was told the boat had been in storage for a few years and the carbs were clogged. I made a low ball offer and it was accepted. Now I am wondering if I should continue trying to get this motor to work or send it in for a...
Top