FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I replaced some fuel lines and a fuel filter on my 1991 Johnson 90hp VRO. I primed the system and as I was doing so I noticed fuel leaking from the two halves of the fuel side of the VRO pump. I took the VRO apart and can see no obivious reason for failure. Is there supposed to be a gasket or...
A few first things first. I would consider myself an intermediate mechanic but a novice when it comes to outboards (lack of experience). I don't want any discussion to take place regarding my VRO either; that debate will not be settled here.
Took my boat out a week ago. Initially started...
I am about three hours away from completeing my 10 hour break-in after a power head rebuild (bore, pistons, and rings). My manual says nothing about what to do after it is complete.
Should I replace the plugs? De-carb? Just take it off double oil mix and hammer down?
Also, should I check...
I bought an 1981 Olympic about a month back. It has a bimini top and plastic side curtains. It also came with what I would call a tonneau cover that goes from the top rear of the bimini to the transom. The problem is that the tonneau cover seems to be several inches too short. I have tried...
Just bought my first boat, an early 80's Olympic 1800 with an early 90's Johnson 90hp VRO. Noticed the steering piston is a little dry and could use some lube. Is there a general purpose marine grease? If not what should I use?
