Re: Volvo Penta 2.1 2.3 Automotive Water Pump Circulation Pump AQ125
Then i pushed the penny inside the hole. With the JB weld to the inside.It fit almost perfectly with the jb weld sealing against the lip inside the water pump.
I then rolled the outer rim of the nickle in the JB weld and...
Re: Volvo Penta 2.1 2.3 Automotive Water Pump Circulation Pump AQ125
Then I hammered the short side of the connector in the hole. Until the gasket compressed against the housing.
Now i had to move on the the extra hole in the back of the water pump next to the water inlet
Again.... Im...
Re: Volvo Penta 2.1 2.3 Automotive Water Pump Circulation Pump AQ125
Here is the aftermath of the redneck hole enlargement. I kept grinding until the connector would barely fit inside. It never would slide in. I wanted it where i had to hammer it in.
After I was done cutting I blew the water...
Re: Volvo Penta 2.1 2.3 Automotive Water Pump Circulation Pump AQ125
I measured the height of the inlet hole on the marine pump from the body to the tip
Then transfer that measurement to the automotive pump and marked where it was to be cut.
I cut the the tip off using a chop saw. A...
Hello Folks. First time post. I recently purchased a 84 Bayliner Capri. It has the Volvo Penta 2.1L AQ125. The water pump was out in it. The circulation pump not the fresh/salt water pump. I check the price of a new water pump and they were all $300 +. I couldnt do this. I did some research and...
Ive got a sport jet 120 with the red stator. No spark condition. I ohm out the Green/white to White/green wire and it shows it is in spec. I check the ac voltage coming out of the 2 yellow wires from the stator and im only getting 3 or 4 volts ac. Shouldnt this be alot higher? I do not have a...
