Recent content by BTate

  1. B

    New engine installation

    Coil lead was removed. Enough spark I could see it from the console while turning the key
  2. B

    New engine installation

    Ok new issue. I got the hole plugged no issues there. Turned the motor over again and was a little dark outside. Noticed that I was getting some pretty good sparking off the top of the coil. Do any of you have a wiring diagram that shows color wires for the coil?
  3. B

    New engine installation

    Oil appears to be coming from the bottom hole. Top looks like a place to bolt an accessory. Hard to get a clear look.
  4. B

    New engine installation

    I had my original engine rebuilt. I figure it was just a plug the shop didn’t replace after they stripped the block down. Had a couple other plugs that were not replaced that I caught during assembly.
  5. B

    New engine installation

    Just finished installing a new 5.7 engine in my 4winns. Almost ready to fire it up. Turned the key to get everything moving and I noticed an oil leak coming from an open bolt hole right above the oil filter. I obviously left something off but can not remember if a sensor or something mounted...
  6. B

    Pointers on replacing Flywheel

    2000 model 5.7 volvo I have a section of bad teeth on my flywheel. Need to replace it. I need a few pointers on things I need to look out for when im pulling my engine. I have done plenty on mechanic work but never had a reason to pull a marine engine. Thanks in advance
See more
Top