Recent content by boydog40

  1. B

    2004 merc xr6 150 oil tank question

    thank you!
  2. B

    2004 merc xr6 150 oil tank question

    thanks! is that the valve that one of the oil tank hoses go to on the starboard side of the block?
  3. B

    2004 merc xr6 150 oil tank question

    just noticed the aux tank on the engine is overflowing (cap is tight) when running and the main tank is only 1/2 full, and she smokes like crazy now until it burns off the plugs. whats wrong?
  4. B

    2004 merc xr6 low water pressure

    impeller is 1 year old ill look at poppet today! thanks
  5. B

    2004 merc xr6 low water pressure

    strong stream at idle gauge states around 4-5psi at 3500 rpm its reads below 5psi still peeing good stream new gauge took thermostats out no change what could it be?
  6. B

    2008 yamaha F150 no electrical power at the motor

    fixed! frayed hot wire to the starter, couldnt see it until i removed starter thanks for all the help guys!
  7. B

    2008 yamaha F150 no electrical power at the motor

    my apologies, it is def a 4 stroke! thanks for clearing that up for me
  8. B

    2008 yamaha F150 no electrical power at the motor

    this one does! 2008 model only power i have to the motor is the power wire to starter and ground and cleaned both connections and have 12 volts there
  9. B

    2008 yamaha F150 no electrical power at the motor

    i have power to the starter and the ground is good replaced the starter relay and nothing, no power to it, no power to the dash, no power to fuse box. all fuses look good too im bumfuzzled as to what could be wrong any advice will be appreciated
  10. B

    gear shift removal

    thanks guys!
  11. B

    gear shift removal

    im pretty boat savvy when it comes to repairs! but this one has me stumped! i need to remove this handle to repair the power trim button, there is a slot at the bottom and usually there is a hex screw on other handles to remove the handle, but i cannot see or feel one on this handle. any ideas?
  12. B

    2008 yamaha 150 no start

    i have 12 volts to the starter, had the starter checked out and all is fine, turn the key and nothing, not even a click, power trim wont work either. all electrical at console works fine, IE depth finder, bilge pump etc. checked all fuses also starter relay? if starter relay, will that keep...
  13. B

    1996 merc 30hp 2 stroke

    will crank up run a few seconds then die, crank back up then die, will do this every time run a couple of secs then die. new fuel pump, new carb kit, new gas tank and hose. not sure where to look next
  14. B

    Used OMC parts supplier

    anyone here have a good source for used OMC parts?
  15. B

    ISO OMC # 0431667 needle

    im in need of part number 0431667 needle (carb) having no luck searching for one goes on my 1973 25hp
See more
Top