Recent content by bob williams

  1. B

    J B FISH EASY

    JB recieved the locator in fine shape, I'm sure I will be happy with it.Good luck with the ULTRA. regards---- bob williams :D :D
  2. B

    fish finders

    been thinking of buying a new one (need input} I have heard all good on eagle units and am thinking about the eagle classic,Cabelas have them for $217, i like it because it has 160 pixels verses the normal 128, I'm not a hard core Bass beater, just like to fish.I've heard too many negatives...
  3. B

    eagle fish locator

    we got caught in a real downpour, when I got home I discovered my locator was full of water (about 1/2 cup worth} I drained it and ran a hair dryer on it without taking it apart, later it turned on OK, it stayed in the garage for a month, today I went to the lake,it turned, but was stuck on...
  4. B

    mariner gear box

    my mariner 40 hp started kicking out of gear going flat out, it would reengage right away though, it also grinds some going into reverse, am i lookind at a lower unit rebuild?
  5. B

    take off

    mailman---i had the same problem with my mariner, i changed plugsnew fuel pump still had problem,cleaned carb twice,new fuel pump but same problem. red sky & walt suggested checking carb. jets, i changed the high speed fixed jet and cured the problem, thjanks to them my motor was saved from a...
  6. B

    mariner carb again

    i could only get the fixed jet from mercury, the low speed jet is NLA; i put the fixed jet in today and runs fine now,it puzzles hoe a jet can wear out, it looked just like the new one. i still would like to fine a new low jet, this part #is from merc (83888M), i think my motor ID is 676B...
  7. B

    mariner carb parts

    fone_man where can i find the modle #'s on my motor?
  8. B

    mariner carb

    sorry, i forgot the id# 676B 41136
  9. B

    1980's mariner carb need low spd. jet

    me again, i'm following walt's advice on the carb jets. i don't need the whole carb kit,only the jets. i got the high speed(fixed jet from mariner, but they don't have the low speed jet.??????? can anyone help mw, or do i have to buy the whole kit?
  10. B

    thanks RED SKY AND WALT

    i remember now about the white gas, thanks again guys. BOB
  11. B

    OCTANE

    THANKS WALT FOR THE REPLY; I HAVE ALWAYS WONDERED THIS MAYBE I CAN SAVE A FEW PENNIES, THANKS AGAIN BUDDY. BOB WILLIAMS
  12. B

    octane

    i have a 1980's mariner 40hp. should i run high octane nolead or is regular no lead OK, also for my 1990 25hp. evinrude?
  13. B

    40hp mariner 676b 411306 carb problems (1980's)

    My mariner is giving me fits, it's on a pontoon and runs fine on low speed, but when I nail it it blubbers and misses. Most of the it will clean out then run fine to full throttle. I have had the carb cleaned twice. It ran better with the air box off, and a little better yet with the cowling...
Top