Recent content by beardy

  1. B

    SE sport 300 to 90 Mariner is this correct position?

    Re: SE sport 300 to 90 Mariner is this correct position? This is a shot before I had a tickle with the rocks on low tide. I stopped to have a mens rest stop over the side and by the time I powered on I was blowen off my heading. It only took a few seconds to have a pee but it shows how things...
  2. B

    SE sport 300 to 90 Mariner is this correct position?

    Re: SE sport 300 to 90 Mariner is this correct position? Ok it is rather dark down under in Australia but I hope the 2 pics I just took shows that the anti cav plate or cav plate or what you like to call it is nearly flush inline with the hull.
  3. B

    SE sport 300 to 90 Mariner is this correct position?

    Re: SE sport 300 to 90 Mariner is this correct position? The problem I seem to be having is the raised area behind the stud for the trim tab and the chamfered area of the yoke. Does anyone know if I should cut out this chamfered area so the yoke fits snug up against the area for the trim tam...
  4. B

    SE sport 300 to 90 Mariner is this correct position?

    Hi folks, I am trying to fit the SE sport 300 to my motorand am not sure if this is the correct position to place. I feel the foil should sit further forward ( towards the boat ) to sit above the prop more, but I can't take any further due to the design of the anti cav plate on the lower unit...
  5. B

    1992 Mariner 90 hp gears help needed

    I have just fitted a new selector cam and bearing carrier and bearings to my motor and am having a bit of a problem. When the selector is in neutral the clutch is clashing slightly with the forward gear. Could this be happening cause the new bearings in the carrier are not set in the right...
See more
Top