Current visitors

Home
Members

airshot's latest activity

A

airshot replied to the thread New Stuff on Vehicles likes/dislikes.

On my Jeep, the temp at which they come on can be adjusted in the dash panel. Just realized it this fall when I found out I could...

Feb 7, 2026
A

airshot replied to the thread Prince craft boats.

Based on my limited exposure the early models had some construction issues, but later models have had few complaints that I know of...

Feb 5, 2026
A

airshot replied to the thread Been a little cold..

Every outboard I have ever owned has the mfgr. stating that their motors should be stored vertically if temps are going to go below...

Feb 5, 2026
A

airshot replied to the thread New project.

I see most newer ones are now electric. I will never own one because at 75, it is to damn cold for this ole boy...and has been for the...

Feb 5, 2026
A

airshot reacted to ShoalSurvivor's post in the thread 4.3 crankshaft/housing oil leak - next steps? with Like.

I was surprised at how easy it was to pull the motor. All of the connections are pretty obvious, and it only took a couple hours to...

Feb 5, 2026
A

airshot replied to the thread New project.

Yes they are very difficult to get started....now I am wondering if that was missing back when I bought it ? Only used it a couple...

Feb 5, 2026
A

airshot replied to the thread 96' Mercury 40hp bore put question.

Unfortunately your in a politically correct state with two strokes just about illegal to have or work on. Here in the great lakes area...

Feb 5, 2026
A

airshot reacted to LaqueRatt's post in the thread 67 Year Old Head Bolts with Like.

Thanks for the prompt replies. I have both a 1/4" hex impact and a 1/2" pneumatic, but think maybe I'll try to work them loose by hand...

Feb 5, 2026
A

airshot reacted to racerone's post in the thread 67 Year Old Head Bolts with Like.

On a fresh water motor they usually come out no problem.----Done more than one 67 tear old motor.-----Pouring boiling water over the...

Feb 5, 2026
A

airshot reacted to Scott Danforth's post in the thread 67 Year Old Head Bolts with Like.

I found that a light snack with a brass hammer on the bolt heads does wonders

Feb 5, 2026
A

airshot replied to the thread 4.3 crankshaft/housing oil leak - next steps?.

Getting the engine out and back in, is the hardest parts to do....good luck...make her ready for spring !

Feb 5, 2026
A

airshot replied to the thread New project.

My augers are old, so mabey something new, but I have never saw an ice augar with a pilot point..

Feb 5, 2026
A

airshot reacted to ShoalSurvivor's post in the thread 4.3 crankshaft/housing oil leak - next steps? with Like.

engine is already out. New timing cover and pan gasket on the way. I will try to pull the seal and consider replacing first, otherwise...

Feb 4, 2026
A

airshot replied to the thread 4.3 crankshaft/housing oil leak - next steps?.

Best job would be to pull the engine....otherwise it becomes a half added job and will probably be needed done again down the road. Had...

Feb 4, 2026
A

airshot replied to the thread Been a little cold..

We have a few that do that up here in Lake Erie, gotta get that last Walleye of the year... A few have ended up with frozen blocks and...

Feb 2, 2026

Show older items

Home
Members

Top