Recent content by AdrianKauai

  1. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    Follow up. 2 x Water tests, first time running amazing... and then the dreaded hesitation blip. Sputter, catch, go. Oh Man turn around quick. Seems to come back to life in harbor. Run it for about 20 mins 1K-4K fine, then clip hesitation. Limp back into dock tie up and she dies. Hard start to...
  2. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    Thanks again, I dodged a bullet @alldodge I posted a success story below.
  3. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    FOLLOW UP SUCCESS ! I hope this post can help someone along the way. Thank you so much @alldodge and others who jumped in to lend a suggestion. Tricky one... I had Pulled ignition module and coil bracket off to inspect harness connection. When getting plugged back in one of the pins folded...
  4. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    Gone through all tests and as far as I can tell everything checks out and all tests performed. Still so spark !!! WTFFFF... Finally I'm back to basic checks and upon checklist found 666 ohms resistance in coil wire, Manual calls for 1000 or more so, off to grab a new one, and keep you posted. I...
  5. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    Checked relay at R5 has 12v power. Switched to fuel pump relay as I can hear that turn on everytime. Checked F4 fuse, F5. All good, and 12v power at one side.
  6. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    Ok, Brand new Cap n Rotor. I prayed. Nadda. Nothing. I'm not getting power to my iginition module, so no power to coil, so no spark. Checked ground to module = good. No 12v on any of the other terminals. I could be at scanner time, but its so weird that all was just fine. Feels like a fuse or...
  7. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

  8. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    Well,I thought it was a brand new cap n rotor, however I just pulled it for S@#%@ n Giggles and .... completely corroded points. You may have been right on the money. Simple and overlooked. I'll keep ya posted.
  9. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    Correct its a Crank, no Start. Getting 12v power to everything except ignition module and coil. So no Spark. Brand new cap n rotor. Fuel pressure solid at 52psi. The day before she started right up and ran like a champ, I was literally just giving her a test warm up before hitting the ocean...
  10. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    .
  11. AdrianKauai

    4.3 GXI-F (2005) No spark or power at the coil. How do I check?

    Hey Guys, 4.3 volvo penta GXI-F model engine (2005). 1998 seaswirl Cuddy cabin She was running and purring just fine... Project boat and just about everything that could be swapped for new has been changed and dealt with. I can list later. Yesterday went out to crank her over, after she has...
See more
Top