FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I ran into a problem while removing my old junky Transom assembly mount and Gimbal. The junky units have Trim senders. The unit I have to replace them( a Transom assembly came with the motor I purchased) do not have Trim senders. What are my option?
I'm getting a pair of Mercruiser 188HP ( Ford 302's) Rebuilt. They are currently 2 barrel carbs with points and condenser. I'm up grading to electronic ignition, 4 barrel Carbs & manifold. My question. Can I use the standard fuel pump or do I need to upgrade to something different.
Thanks
Correct me If Im wrong, I just want to be sure. When you get water in cylinders the cause can be 1.bad/cracked intake. 2.bad exhaust/risers 3. water comming back into the exhaust. To CMA Im planning to replace the intake and exhaust manifolds elbows and risers. Long story..
Thanks
I am putting a motor back together that just had the cylinders honed.(flash rust from a bad intake manifold) Everything was going great until I torque the conntecting rod nut to Jug 3 and or 4. When either of these pistons are torqued to to anything over 20ftlbs the crankshaft wont move.
The...
I am getting ready to install three motors into two different boats. (when it get warmer)Whats is the most common overlooked mistake people do that bites them in the butt later on?
thanks.:D
