Hey guys, I haven't attempted this one yet, nor do I have the manual yet. Can someone get me started on changing the water pump impellor on this guy? Thanks -Chris
I have a 1997 40 hp Force and I was wondering if I can do a carb upgrade or something to get more horses out of her. Any input would be greatly appreciated. thanks guys -Chris
I have a 1997 40hp force.(which says by Mercury on it. I just wanted to know what are the best spark plugs(NGK etc..) to use. What octane fuel should I run? and is the water pump impellor easy to change on this. Thanks in advanced ! -Chris
I recently rplaced the retainer plate behind my carrier housing and noticed half of a tooth was broken on my drive gear coming down from the upper housing. My quetion is can I use it this weekend because I have had this trip planned for six months? Thanks guys, I know this is a stupid question...
Does anyone know where I can get a carrier housing retainer for 1990 4.3L OMC ?<br />Oh and Don I know you are sitting there reading these posts and it is driving you nuts not typing a response. c'mon go ahead a start typing please. I need this retainer dang it!
When I removed my carrire housing in my OMC I noticed the 4 screws that attach it were stripped. I know this is not normal but where can I get the screws with the seals that go on them? and are there any tricks to getting the old prop shaft gasket out with nicking or screwing up the carrier...
Ok guys lets start here, when I took my boat out last weekend I noticed on my post inspection that the prop was loose due to the loss of the cotter pin and the nut backed off a little. luckily I did not lose the prop. Tonight I lowered the drive and noticed all of the gear oil sitting in the...
I cant get past about 3500 RPMS. 4.3 OMC 21 pitch prop.(which I think may be the issue but I wanted a second opinion) 17.5 ft open bow stratos about 3300 lbs. When I trim way up it gets up there close but it jumps out of the water.
Have we come up with the solution on the building of the electric shift box for the OMC application. Epoxy, Shrink wrap, etc...? I would like to know for refrence Thanks -Chris
Would anyone happen to have the Part # for the revised shift cable from OMC? 1990 4.3L King Cobra 800. (All I think I know is that the new one is red? Thanks -Chris
Hey guys how is everyone? i wanted to know if anyone knew where I could an electric ignition upgrade instead of using points and how much are they? thanks Chris