Hi I have a 1982 115hp tower of power. A few years ago I noticed gas dripping out the screw on the bottom if the carb opening...although it is painted and a boat shop telling me there would be no reason for gas to come out of that screw...I removed it and put permashield fuel gasket on the...
Very strange things today. Planned on taking the boat out. Start to trim it up to put the transom saver on and only went up a quarter of the way and sounded like the battery was dying. That's not the case battery was fully charged. Never heard or sern anything else as far as noise. Now its for a...
1982 merc 115 HP. Really not sure what part is junk. I have a Quicksilver shifter. One button for trim up and down. And a trailer button. Trailer button and up all I here is a clicking noise. But pump runs if I trim down. Has fluid, full new battery, I can make it trim up by jumping the red...
1982 merc 115 HP. Really not sure what part is junk. I have a Quicksilver shifter. One button for trim up and down. And a trailer button. Trailer button and up all I here is a clicking noise. But pump runs if I trim down. Has fluid, full new battery, I can make it trim up by jumping the red...
Im in trouble now. after unsuccessfully trying to wire in a 5pin tachometer harness to more than likely the wrong style tach. I was going to take my 5 year old fishing. no go. motor would not trim up. i just get a clicking noise. pump sounds like it will work if i push he button down. but...
just purchased the 5 pin wiring harness for my quick silver control box. The tach I have only has a negative and positive terminal. I connected the purple wire to the + and the grey wire to the - terminal. I then attatched the black wire to the tach mounting bolt to ground itself. I am also...
Hi all, wondering if a lower unit from 1987 motor with serial #OB145472 115hp merc, will fit my 1982 115hp merc serial #6093810. iam looking to buy the lower unit off the 1987 motor because the power head is junk and can get it cheap, and can get me on the water this year. Wondering if the...
Well, I have a 1986 maybe 20hp mariner tiller, long shaft with a weird serial # 6633973. Anyway never really had problems until I had out the last time. Only the
top plug had spark, moved the wires around on the coil packs and find out the coils are fine. I see a few ways to test the stator...
i have a 1982 115hp merc 6cyl 20 inch shaft drive witha 26 pitch 3 blade stainless prop. just installed this motor a month ago had it out once with no problems changed the gear oil before i had it out.
took the boat to the river today left the landing went about a half-mile turned around...
well i finally found what i think is a good used motor to swap out my old thunderbolt ignition 1150 merc the above mentioned motor caught on fire at the landing last year and was enough to keep me warm for about 2 mins.
started from fuel vapors and a strange spark inside the cowling dont know...
