To get the fore deck to drop at a right angle so the trim work will mate up, I figure add at least three inches. The floor block could probably be fu
To get the fore deck to drop at a right angle so the trim work will mate up, I figure add at least three inches. The floor block could probably be fu
Since all these SCs should be the same, this is the length from last deck seam to anchor wall.
Need to use your imagination here. Used scrape molding held together by a hot glue gun to form template. Cut inch or so larger, then scribe to wall
Starboard side trim fit. Notice holes in the salvaged metal. Someone had mounted pole holders and canopy hardware on them.
X-ray vision again here. This is how it's attached to deck and other is for interior shelf support. Note, had to have enough bow deck to attach 2x2.
Use your x-ray vision here. I added a piece of 1x4 cedar, leaving the metal half inch longer to account for plywood wall. As will see later, should
This is view under bow. When I started, my major concern for this area was size to accommodate anchor and rope, not how it would effect the finished
W

To get the fore deck to drop at a right angle so the trim work will mate up, I figure add at least three inches. The floor block could probably be fu

There are no comments to display.

Media information

Album
70 Starcraft Jupiter Restore/Modification
Added by
West Coast Willy
Date added
View count
211
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Top