How to adjust the needles ON 200HP?

[jiffyboat]

hi, I have a Evinrude 1996 model E200TXEDR I don't find the way to readjust the needles back after rebuilding the carbs, I readed that post at the beginning , but it doesn't says any thing about the six cylinders, besides I notice that it spits every 2-3 seconds out of the exhaust, ..when I pulled the needles to clean the passages, I first turned the inside I they were like 4,5 turns in , I think that to much , I did tried different ways and this one is the way the motor better runs...any advice from the experts ..thanks ..I still don't understand why it spits out of the exhaust

 

[ezeke]

Re: How to adjust the needles ON 200HP?

The initial setting for the 1996 200HP 90? engine is 5 turns out from gently seated.

Make sure that the throttle plates are fully closed at idle and perfectly synchronized, and that they are horizontal at WOT. All of the throttle plates must be perfectly synchronized through their entire range of motion.

 

[jiffyboat]

Re: How to adjust the needles ON 200HP?

thanks for the info I will try that tomorow and I will let you know