I have a 1983 Lowe 16B (Bass) Catcher Pro. Net Wt. 530 lbs., 4 persons or 490, for a total load cap. 920, 16" 0' length, beam 64", transom ht. 20".
I need to figure out where the lifting points will go. This will be for lifting the boat using a cable hoist and nylon slings w/shackles attached to the boat at it's lifting points.
Vessel lifting points must have backing plates with minimum dimensions of 3? x 3?x 1/8?. Stainless steel plates are recommended.
So do I buy this lifting hardware. I know I have to buy the slings and shackles, but the thing the shackle attaches to that is mounted to the boat, do I have to buy that, or have it made? Also, how do I determine where these are mounted on the boat.
Any help here or direction would be greatly appreciated...thanks again.
I need to figure out where the lifting points will go. This will be for lifting the boat using a cable hoist and nylon slings w/shackles attached to the boat at it's lifting points.
Vessel lifting points must have backing plates with minimum dimensions of 3? x 3?x 1/8?. Stainless steel plates are recommended.
So do I buy this lifting hardware. I know I have to buy the slings and shackles, but the thing the shackle attaches to that is mounted to the boat, do I have to buy that, or have it made? Also, how do I determine where these are mounted on the boat.
Any help here or direction would be greatly appreciated...thanks again.