Welcome Guest - Sign Up today
Welcome Guest - Sign Up today

Announcement

Collapse
No announcement yet.

No start on one engine

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • No start on one engine

    Had an no start condition on one engine. It was fine, then it wasnt. we were just drifting, and then would start up and move. after about 3 times, starboard engine would not start. Checked all things electrical, and then it was getting hard to shift in and out of neutral to the point it was stuck in reverse. Hobbled back to the dock on port engine, then played around with starboard side, and it would now shift into nuetral, forward, etc. But still no start. Is the neutral position switch inside the control mechanism? Any way to change that, check it, etc?

  • #2
    Sign up today
    If it was a Bravo drive I would say its the neutral safety switch, and when its in gear and motor is not running, it takes some doing to get back in neutral. Most cases the neutral safety is in the throttle control, unless its a newer model then on the shift plate or transmission for inboards

    I'm assuming its VP because its in this section, but no mention of motor or drive?
    94 Formula 27PC Custom 509MPI MEFI3 , B3 XR
    95 Rinker 232 w/ 7.4L Carb 0F425011 B1 0F486471
    07 Seadoo GTX
    Merc Adults Only VP Adults Only
    G-Dad always said "First Liar doesn't stand a chance"

    Comment

    Working...
    X