vidsdinerie
Cadet
- Joined
- May 11, 2013
- Messages
- 19
I have a 1975 Evinrude 25 I am replacing the impeller and pin. I have a factory service manual and the instructions state to oil the impeller and slide down driveshaft. Can someone familiar with this engine let me know what oil to use and where to apply the oil to the impeller. I assume it means just to add some oil to the ID of the impeller but I want to make sure before I put it all back together.
Also what grease is ok to use on the upper spline of the driveshaft above the oring to the crankshaft.
Also what grease is ok to use on the upper spline of the driveshaft above the oring to the crankshaft.