I have a Minn Kota trolling motor (Endura 50lb) and I would like to extend the power cable approximately 5 feet, without cutting the original connectors. I'd also like to put a quick disconnect near the original leads. I'm thinking trolling motor terminals, to something, short 8 ga wire to disconnect, then 8 ga wire from disconnect to battery.
I've seen people who wrap and tape wire around the terminals of the stock lead but I'd like something a little more sturdy. Can this be done by simply using a small nut and bolt to connect the stock motor power cables to the terminals that will be coming off the quick disconnect (and taping/ insulating the connection)?
Tldr: What's the best way to extend trolling motor power wore while leaving the original terminals in tact?
Thanks.
I've seen people who wrap and tape wire around the terminals of the stock lead but I'd like something a little more sturdy. Can this be done by simply using a small nut and bolt to connect the stock motor power cables to the terminals that will be coming off the quick disconnect (and taping/ insulating the connection)?
Tldr: What's the best way to extend trolling motor power wore while leaving the original terminals in tact?
Thanks.