I have a 1993 celebrity 180 Status. Bow rider it is 18 ft long with a alpha 1 out drive 1:84 gear ratio. I just purchased a new marine blueprint 383 stroker with 405hp and 450ft/lbs of torque. How hard is it to do this swapand what problems will I run into, wiring/ motor mounts or anything like that? Also it had a stock V6 that would push it 53.4 mph on gps what mph gain should I look for and will that alpha hold up I know they are rated for 300hp. I'm doing a thru hull exhaust and looking to buy some performance manifolds. Any ideas or suggestions would be helpful I have already got the 383 and have a bravo 1 if i need to use it. I'm hoping to get at least 65mph or maybe even 70 out of it but I know that's gona be hard for a ski boat hull. But it's a light small boat with a good bit of hp. I will def have to reprop I'm running a stainless 23 picth marage. Thanks