I finally got all the wiring done for the the limit and sender switches. My issue is this. The boat is in the water and I can not take it out right now (no trailer). I need to adjust both limit and sender switches on the drive. The only way I can really get to them is when the drive is tilted all the way out. The manual gives directions for adjustment with the drive all the way in. Can someone tell me how to adjust the switches properly while the drive is all the way out and in the water? Currently my trim gauge is pegged at the bottom when the drive is all the way down. When i move it all the way out it just moves about a 1/4 of the way up. As far as the trim limit. Currently the trailer up brings the drive all the way up fine, but the trim also goes all the way up and down. Dosent stop the drive at a safe position. Im not sure how high its supposed to go with the trim vs the tilt.