Help!!! I recently purchased a 1989 Renken 200 with a OMC 4.3 2bl carb and cobra drive for the low low price. previous owner stated everything is good but it needs fuel pump and carb rebuilt and he gave me a new off brand fuel pump may be a Carter but there is no numbers on it but D05...bought it fast got home and rebuilt carb and new fuel lines, pumped tank out. Got to the fuel pump and started to adjust the rod to fit the pump and the problems began... Fuel pump rod on this 4.3 does NOT go vertically but side to side and it was broke in half, got the rod out and went to summit and bought a new rod for a 1989 4.3 engine. Got home and the rod protrudes out the fuel pump housing so its to long. Rod length measures 5.75 inches. Did some research and found the OMC rod is 5.065 inches long and the only place I found it was on ebay and the guy wanted 52 bucks for an obsolete $10 part. bought it installed it but even with the rod in as far as it will go, still there is no way the fuel pump can fit without breaking. So I turned my attention to the fuel pump. went to napa and they gave me the same pump I already had. what the ^%&$ am I doing wrong???