hello again guys . today i tackel my first engine alignment as am tiping right now i got pain all my body , i must have climb in and out off the boat about a thousand times. i started out with with the tool not going in the coupler after searching this forum and watching youtube videos i manage to get the tool in and it was going in like butter. now i turn the engine over a bit and it gets tight again i adjust it antil it nice again. i now turn the engine over by hand again it did change a bit again. i to mk a long story short with all the turn over off the enging the problem is am getting heavy spline marks not direct on top but slightly starboard side. the heavy matks is about two o clock . which front mount is too high or too low. thanks much.