I have reviewed the different ways to remove gimble bearing but before I start cranking on a bearing puller I want to be sure there is no retaining ring holding the bearing in place.
My drive serial # is OL935713 do I set up the puller and just crank?
I have not removed the bellows assy can the bearing be removed through it.
Update, Had to drill it out spent 2 hours drilling 3/16" holes in aluminum outer ring then opened up every other hole to 1/4" installed bearing puller and it slid out easy.
If you read the full post you will see the progress.
My drive serial # is OL935713 do I set up the puller and just crank?
I have not removed the bellows assy can the bearing be removed through it.
Update, Had to drill it out spent 2 hours drilling 3/16" holes in aluminum outer ring then opened up every other hole to 1/4" installed bearing puller and it slid out easy.
If you read the full post you will see the progress.
Last edited: