Motor has been running fine all summer. Fired it up in the driveway before heading out and noticed that it sounded like it was running on both cylinders. It would idle really low then rev back up to where it sounded like it should. Put it in the water and rode around for a while and it continued and then finally cut off.....never to crank up again. It would turn over but wasn't getting any spark. Plugs and wires are good. Carbs are clean. Good gas/oil.
I unplugged the big red harness plug that goes from the boat battery to motor. Noticed some corrosion on the prongs and knocked it out. Plugged back together and now there is NOTHING. No power to the motor at all. Is there an easy way to bypass the harness?
Or any other suggestions??
I unplugged the big red harness plug that goes from the boat battery to motor. Noticed some corrosion on the prongs and knocked it out. Plugged back together and now there is NOTHING. No power to the motor at all. Is there an easy way to bypass the harness?
Or any other suggestions??
Last edited: