A few years ago, ******** was closing out their rebranded Scotty rod holders in white. I snagged 4 of each style with mounts. We installed the 8 mounts around the boat.
Had to do a little trimming to fit over the transom tie down U bolts. Also, had the manufacturer send out a couple more support rods to fit with the trim tabs I planned to install.
Still need to get caught up on the rest of the installation and improvements. So, after lining up and fitting the swimstep, and getting the new supports, I was able to mount the swimstep with the exception of the support tubes. I still needed to install the trim tabs to make sure the support tubes did not interfere with the actuators. Unfortunately, the transom has a slight curve on the bottom where I was installing the trim tabs.