Search results

  1. W

    Tacky Gelcoat

    I was looking for some gelcoat help. Prior to the winter I needed to replace the gas tanks in my center console. I figured, while the floor was up and out of the boat I would put a new coat of gelcoat on the deck. I sanded the surface & cleaned it with Acetone. Once everything was dry I applied...
  2. W

    Need Prop guy for Inboard - LI NY

    I am in need of prop reconditioning on my Inboard props. I live in Long Island NY and was wondering if anyone had a name of someone.
  3. W

    Raymarine Multi Function Display Flickering

    I have a Raymarine MFD with LightHouse II Release 19 software on it. This is on a Center Console with 200 Yamaha Outboard. When I have the GPS on at the dock and Motors running no issues with the display. Once I go out and give the boat power the display starts to flicker. I have put all the...
  4. W

    Mercrusier 350 MAG MPI - RPM issue under a load

    I am looking for some help on an issue I have been working on for a few months and it has kicked my butt. I have a Mercrusier 350 MAG MPI rebuilt block. The motor at idle has no issue reaching 4k+ RPM's. The issue I am having is when I try to get the boat on a plan, I cannot get the motor...
  5. W

    1998 DT225 RPM issues

    I was looking for some help on an issue I am having. I have a 1998 DT225 Suzuki EFI and I cannot get the boat past 1000 RPMs under a load. In neutral all is fine. I have looked all over the forums and cannot seem to find a solution. I have changed the following this winter. Plugs, Oil...
  6. W

    1977 Chrylser 360 cuts out at 2500 RPM's

    I have a pair of 1977 Chrysler 360 inboards with electronic ignition. My one motor drops off RPM's at 2500 to about 1000 and jumps back up to 2500 until I slow her down. I can run for a while at 2300 RPM's with no issue. I have cleaned the Carburetor, replaced the coil, Ballast resistor and...
Top