Search results

  1. B

    1998 johnson 90hp pleeb- no tach

    Hi gang, i had no tach no charge, installed new rectifier ...got charge back....but still no tach....its a new part that has no purple lead....just wondering if that is why i have no tach? Other than that i have no idea why no tach Guage display....any ideas? Thanks
  2. B

    break in procedures 90 hp johnson

    cant seem to see them in FAQ can someone direct me...90 hp johnson thank you
  3. B

    hooking up rpm guage

    i have an J90PLEEB 1999 90 hp johnson...it has the new type plugs to hook up to controls....i recieved this motor disassembled....have rebuilt and bought 2003 omc controls for it.. everything else is hooked up , but for initial start up i need an rpm guage... i have the typical "tiaga"...
  4. B

    j90pleeb 90 hp

    i just rebuilt this motor all new...i used permatex 518 gel seal between the crank cover and block...ive left it for a few days in an unheated garage....its been up to 17 above 0 for all days and a lil colder at night....not much...but the gel thats oozed out around the edges ahs not set or...
  5. B

    number one,two etc. cylinders?

    well the old 110 died on two cylinders after a few years....iboats helped me fix that one heres the new motor rebuild ...stupid question ---- >j90pleeb 4 cylinder ? cant remember which is number one and so fourth. i know this has been answered before , but i have been searching and cant...
  6. B

    just wanted to say thank you

    just wanted to say thanks to all that helped me with my new (used) boat. =) me and my family have been eating prawns non stop sisnce i got it running . i will continue to try and be a part of this site as it helps many people in different ways . thanks to iboats and all that are part of it . =) =)
  7. B

    carb kit

    1989 vro evinrude 110<br />ok i got the new carb kit, i got the carbs off, how much disassembly of the carb is necessary. its not gummed up , but the kit came with float ,float valve and brass seat valve,gaskets and several o-rings ....i cant seem to see where the o-rings are need ....unless i...
  8. B

    impeller fins ? which way ?

    which way do i point the fins of the impeller ? in dirrection of travle ? clockwise ? or opposite ? or does it matter? thanks
  9. B

    1989 evinrude 110 vro compression

    i got 95 95 100 95 <---- is this ok for now or should i be concerned? what should it be ? thank you.
  10. B

    over heat alarm

    1989 110hp evinrude v4 crossflow....i recently installed 2 new thermostats into this motor. i wasnt having overheats problems until i did this.i was careful to assemble correctly <br /> <br /> the supplier of the parts only had 1 grommet and relief valve . i had to leave 1 of the old ones in...
  11. B

    evinrude 110 horn alarm

    1989 evinrude 110hp , the vro has been disconnected and 50:1 fuel is mixed....i finally got his engine running....replaced power pak to solve ...after running it for a few days i decided to take it to the lake for a test...i need some minor carb adjustments..., but after i ve ran this thing for...
Top