Search results

  1. S

    Central florida fishing club

    Im looking for about 10 teams to fish tournaments in and around polk county. We would be holding more than just bass tournaments, speck, and catfish are just a couple possibilities. What i would like to see happen is , several unofficial tournaments for the 2014 season, and if intetest persists...
  2. S

    wrong stator

    I have an 88 evinrude 150, my stator went bad, i have a new cdi stator available, part number 173-3117, the correct part number for my motor is 173-3668. The look identical and have the same wires, both are 35 amp...my question is what could go wrong by using this stator? Will it run bad,? the...
  3. S

    firing order and cylinder location

    I have an 88 evinrude 150xp, e150stlcca, what is the firing order for this motor as well as the cylinder arrangement? Thanks...
  4. S

    stator wiring problems

    I have a 1988 evinrude 150xp, my stator is disconnected from the power pack......no plugs.....one wire is brown, the other is brown with a yellow stripe....on my stator, two brown wires are ran through plastic tubing (insulation) and tge two brown/yellow stripe wires are ran through another...
  5. S

    stator wiring problems

    I have a 1988 evinrude 150xp, my stator is disconnected from the power pack......no plugs.....one wire is brown, the other is brown with a yellow stripe....on my stator, two brown wires are ran through plastic tubing (insulation) and tge two brown/yellow stripe wires are ran through another...
  6. S

    vro disconnect

    How do i disable my vro on a 1988 evinrude 150xp? Im not starting a debate here, everyone has a reason to disable or not to disable......ive not faired very well with automatic oiling systems, and i dont trust them anymore than our government ;-) , i can mix my fuel right on the money, just need...
  7. S

    drilled exhaust holes,,,,

    I see people drilling holes in there mid section of their outboards, it sounds good, but does it hurt performance, or the engine., i would think it would alleviate back pressure, and actually help hp. ...any thoughts or ideas? I have a 1988 evinrude 150xp, where would i drill these holes...
  8. S

    will this lower unit fit?????????

    Ive got a 1988 evinrude 150xp, i have a chance to buy a lower unit from a 1990 johnson 200hp for a good price, just to have as a spare. thats all i know about the motor is the year and size till after xmas...,,does anyone know it the lower unit will fit my motor?? Thanks
  9. S

    what prop?????

    I have an 88 stratos 19ft f/s, with an evinrude 150. Im not sure of the current prop size, but ill post it later. I do know i have no jack plate, and wot is 5200 with a top speed of 50 (gps) the hole shot is mean, feels like your gonna rip the transom off, but im thinkin i can get a little more...
Top