Search results

  1. J

    Bass boat bow control panel.

    Re: Bass boat bow control panel. Hey Silvertip, thanks for getting back. I did forget to mention the run charge switch. I kind of gave up on that one a while back knowing that I would have to run my 6 amp output system from the motor for a long, long time in order to charge even a single lead...
  2. J

    Bass boat bow control panel.

    Hello. I have a 1982 glastron Hpv165 bass boat. Can anyone tell me why on the bow electrical control panel there is a 12/24 volt plug, check batt#1&2 switch and a volt meter but no 12/24 volt selector switch? I understand that there are both 12 and 24 volt motor set ups but why have a dual...
  3. J

    1982 Johnson 115 inconsistant idle

    Hello. I have a 1982 Johnson 115 with hyd. tilt/trim. I have a problem with inconsistant idle. This motor Idles rough on muffs at around 1000 rpm. Idle is at about 850/900 rpm on water in nuetral. And just in gear at 600 rpm. The problem is when throttled up just a tiny bit to maintain a...
  4. J

    Advice on Wipers.

    Does anyone out there have any advice on catching Wipers when the water temperature drops below 70 F?
  5. J

    1982 Glastron HPV 165 re-powering questions.

    A few months ago I purchased a new to me old 1982 Glastron HPV 165 Bass boat with what I am guessing is a 1982 Johnson 115 outboard with hydraulic tilt/trim. The boat has a few stress cracking areas in the gelcoat but nothing major in my opinion. However, the transom has me wondering if there...
  6. J

    1982 Glastron Hpv 165 bow electrical panel

    Hello everyone. This is my first post. I was wondering if anyone out there has a hull wiring diagram for a 1982 Glastron Hpv 165. I bought this boat about two months ago and have been doing little things here and there in between fishing trips to try and get this boats original equipment back...
Top