Search results

  1. K

    '75 Crestliner Apollo 660 Transom replacement

    I need to replace the transom on a '75 Crestliner.(see photo). I have a few challenges to overcome in order to replace it and need some opinions. The transom fits in behind the splash well on the inside (see yellow arrow). I can't just tilt the new transom into place because of the support...
  2. K

    1975 Crestliner Apollo 660 replace keelson

    I'm rebuilding the stringers and transom in a fiberglass '75 Crestliner. After removing the stringers, I noticed water coming out from the center of the boat and under a layer of 1708. After some sanding, I found a 2" piece of wood about 9' long running from the bow to the transom that was...
  3. K

    75 Crestliner stringer replacement project

    I have to replace the rotted stringers and floor on a '75 Crestliner Apollo and need a little advice. After removing the stringers, I still have the fiberglass mat that was used for tabbing attached to the hull. Do I need to completely remove the old fiberglass tabbing or can I grind it down a...
  4. K

    No spark on cylinder #1 1983 Johnson 75HP

    Took the boat out and it wouldn't run above an idle. Any throttle movement caused the motor to stall. I took it home and found that I'm not getting spark on cyclinder #1 but 2&3 had spark. I switched plugs and wires and had the same problem. I, then switched the orange coil wires on #1 and...
  5. K

    1983 75HP Johnson tilt/trim motor

    Hi all, my tilt/trim motor doesn't work all the time. I think the motor is bad because if I tap it with a hammer it'll start working. However, for my question, when testing the voltage I noticed that I get 12V on the blue and green wires regardless of whether I'm pushing the up or down button...
  6. K

    1983 75HP Johnson tilt/trim motor

    Hi all, my tilt/trim motor doesn't work all the time. I think the motor is bad because if I tap it with a hammer it'll start working. However, for my question, when testing the voltage I noticed that I get 12V on the blue and green wires regardless of whether I'm pushing the up or down button...
Top