Search results

  1. jrboat2011

    upper transom corner caps

    does anyone know where I can find corner transom caps for a sea nymph 17 ss I bought a pair off a Starcraft, but they are not the same fit
  2. jrboat2011

    yamaha outboards

    when did Yamaha start selling outboards in u.s. has anyone heard of a 1971 9.9 four stroke?
  3. jrboat2011

    Carb. ajustments 1975 70hp johnson {70esl75e}

    I just rebuilt the Carbs on this motor, the Seloc manual says that the type 1 Carbs, for this otor has fixed low and high speed orifices , How can you adjust the high and low speeds if they are fixed???
  4. jrboat2011

    Rectifier {70esl75E } Johnson

    What is the purpose of the rectifier , I can't find it in my Seloc Manual it has a frayed red wire leading to the power pack.
  5. jrboat2011

    1975 Johnson 70esl75e Coil Queston

    I was not getting Spark from #1 cyc. so i swapped the Coils on #1 and #2 Cy. Now I get 7/16 White Spark on all 3 CyC. Question? should I be Concerned ???
  6. jrboat2011

    no spark for coils Johnson 1975 70hp {70esl75e}

    I am not getting spark on all three coils, when using a spark tester, HELP Please
  7. jrboat2011

    Nut that holds flywhell on

    How is the best way to remove the nut that holds flywheel on, flywheel turns when I try to loosen nut.
  8. jrboat2011

    "pee hole, 75 70esl75e

    wear is the pee hole located on this motor, I cant Find one any where on the out side of the engine
  9. jrboat2011

    Carb. rebuild kits 75 70hp {70esl75e}

    Is the Rebuild Kits for this engine the same for all 3 carbs.
  10. jrboat2011

    75 70hp (70esl75e} will not start

    After sending fuel to engine from tank, fuel runs out of lower carb, engine will not start, this engine has been setting for about a year , while I restored the boat { 17ft Sea Nymph SS } engine has 125 compression on all Cyc. do I need a Carb. rebuild???
  11. jrboat2011

    compression 75 70hp 70esl75e

    I have a 70 hp 1975 Johnson that has 125 psi on all 3 Cyc. is that a fair compression ???
  12. jrboat2011

    decabronizing

    what is decarbonizing and how is it done ???
  13. jrboat2011

    Johnson 75 70 hp bearing carrier bolts to retainer plate

    replaced prop shaft seals and bearings , can't get bearing carrier bolts to set in retainer plate, feels like they are to short, but I am using the bolts that held the carrier to retainer plate before I replaced the seals and bearings.
  14. jrboat2011

    bearing carrier bolts

    I am having a problem getting the bearing carrier bolts to seat, I have guide bolts holding the retainer plate in place , but I still can't get the bolts to seat, it feels like to bolts are too short to start the treads into the retainer plate,
  15. jrboat2011

    35 hp evenrude #35803r (Themostat)

    Can A bad Thermostat cause restriction in water flow, and is it ok to run with out one? should it be replaced when the water pump is replaced?
  16. jrboat2011

    35 hp evenrude #35802R Upper Driveshaft Seals

    What is the best way to replace the upper Driveshaft seals
  17. jrboat2011

    OMC `1974 307 with 4mv quadrajet,

    I can't get idle down below 1000rpm or it dies, carb has been rebuilt, Timing is right on mark 8 BTDC need Heip?????
  18. jrboat2011

    water problems 78 35 hp evenrude #35802r

    I have put a new Water Pump Kit in, as per instructions in the Seloc Manual, I am not getting water out of the PeeHole or the Two exhaust holes in the rear. Is there other areas that can stop on slow down the flow of water that iI may have missed, I have not run it in a Tank yet, just the clam...
  19. jrboat2011

    35 hp evenrude model 35802r

    I have installed a new water pump repair kit on this motor, can any one tell me , after starting, how soon should I see water coming out of the "pee" line. I ran the motor for about 2 minutes , but no water,???? This was with clam shell type device attached.
  20. jrboat2011

    signs of Water In lower unit

    How can water get in lower unit? not much be oil is a little milky.
Top