Search results

  1. R

    94 mariner lost 1000 rpm

    Boating last weekend. Running WOT at about 5100 rpm, hit some wakes at full speed. Usually no problem in my 17.5 key West. Just out of the wakes lost power and rpm. Had do get back at full throttle in plow mode, could not get on plane, and 4000 rpm. Every 10 seconds or so it would surge, or try...
  2. R

    Deep Impact Yachts??

    Just saw these. Who can run Quad 350 Verados. Cmon 130 gallons per hr at speed. Bad bottom rigs though. Will turn a head.
  3. R

    New stuff: Catastrophic failure

    Just got all new 2000 lb axle, bearing buddy hubs, leafs, hangers, brackets, hardware, new LoadStar 14 inch wheel tires...all of it. Put under a 1400 lb rig and went 3 miles.. total leaf spring failure. One went straight flat, the other looks like a "W". the W leaf sent the brand new tire...
  4. R

    FREE oil tank

    Pulled the oil reservoir off of my 94 75hp Mariner. Disabled the pump and am going to premix. Lots of room under the cowl without the tank for wire harness etc.*****EDIT***** Just dont trust the system on an older motor. It probably only has a few years left, so I dont want to make it work to...
  5. R

    Mounting spare with a hub ideas

    Put an entire new axle under my Aluminator trailer. The old axle was junk, but it did have new hubs on it. I went from 13 to 14 inch wheel/tires. I would like to carry one of the 13's with the good hub as a spare. I know that they are of a different size, but it is after all a spare for...
  6. R

    94 Mariner 75hp gear shift question

    Pulled off the lower unit to change water pump. No problem. cannot get the lower unit to go into N on the bench. Did not have any problems before removal. Can rotate the LU shifter about 180 and go into R, but I have to hold it there. Put it back on the motor after a hell of a fight to get...
  7. R

    Hangers for an Aluminum I Beam trailer?

    I am changing the axle, springs and all hangers and hardware on my Aluminator I Beam trailer. All of the hanger brackets that I can find seem to be made for Box beam trailers. All of them have mount bolt holes for the center line of the trailer. That will not work for an I beam trailer. The...
Top