Search results

  1. D

    Motormounts 180 deg. off, will it matter?

    1) I have a 1989 sleekcraft 21' modified V hull w/350 Mag-alpha 1 drive. After destroying the lower outdrive at Lake Havasu last summer I just replaced it with a SE106 from Stren Drive Engineering. I also replaced all the bellows, gimble bearing etc.. During reassembly I needed to make a slight...
  2. D

    broken alpha1 drive shaft , now questions

    On a recent trip to Lake Havasu after only an hour there I hit rocks and broke the driveshaft just below the spline where it goes into the upper unit. In addition I bent the prop shaft .016", gouged the skag, and gouged, nicked, and slightly bent the prop. Both shops that gave me estimates were...
  3. D

    vintage ski-sled info needed

    I had a towable in the mid 70's that WAS NOT inflatable. It consisted of 2 short fiberglass ski's and a padded round seat all connected by a metal tubular frame that were also connected with linkage so when the seat or ski's were leaned either way everything leaned together. When riding this...
  4. D

    Info needed for 1989 sleekcraft

    I have 2 questions about my boat. My first question is can anybody help me determine the model of my boat? It is a 1989 21' Sleekcraft open bow, it has a semi-V tunnel hull with a 350 Mag and alpha 1 drive, the numbers on the hull are as follows; SLED3114J889 PAT NO 244841. If anyone can...
  5. D

    alpha1 trim/tilt, very slow up/down works ok

    I have a 1989 alpha 1 that works fine going down but it takes 3-4 minutes to lift up. There is no water in the pump resivour and in 30 hours it has used no hydraulic fluid at all, Any ideas or help will be appreciated!
Top