Search results

  1. F

    Oil pressure gauge

    93 4.3L with Gen II drive. When I turn the ignition switch on the oil pressure gauge pegs at 80lbs. Stays there when engine is running. If I unhook wire at sending unit, gauge reads zero. Replaced sending unit today. Getting same symptoms. Tried testing the new sending unit today with VOM...
  2. F

    Alpha I Gen II gear lube leak

    I have an 1993 Alpha I Gen II with no gear lube reservoir. I have gear lube coming out of the water intake screens on the the lower unit. This boat has not been run yet this year and was just pulled out of storage. Looking for direction on what seal(s) to check/replace.
  3. F

    What alternator do I have?

    I am wanting to put a deep cycle battery in my boat for the stereo system. I plan on using an isolator to help charge the battery while on the lake. I need to know the type of alternator I have to know if I need a 3 or 4 terminal isolator. My engine is a 1999 5.0 Mercruiser Alfa I Gen II...
  4. F

    Replacing transom need help

    I am replacing the transom in a 1993 Crestliner aluminum 19ft with an I/O. I am wanting opinions on what to use to laminate the plywood together and then what to use to seal it. The current transom is out(fairly easy job), and is made of two 1/2in pieces of plywood and one smaller piece of...
  5. F

    93 Alpha I problems

    Ok, Hi all. I have a 93 4.3 with an Alpha I that I bought last fall. The drive serial # is OD889087.This boat was an Indiana DNR boat and has 2200 hrs on it, and it spent summers docked in fresh water. I have a few problems so I will start with outdrive questions. I have Chocolate colored...
Top