Recent content by mv6767

  1. M

    1979 Johnson 35 question?

    Is it normal to have exhaust coming out of the two holes on the exhaust housing just above the lower mounts? Motor has been running great otherwise.
  2. M

    Adding tilt and trim to a 1973 Johnson 135

    I have a 1973 Johnson 135 that I would like to add tilt and trim to. Is this even feasable and if so would using the mount assembly off a newer model be the route to go?
  3. M

    Mounting kicker motor

    I am wondering where would be the best location and what mount to use to put a 15hp Johnson kicker on my 21 ft Mariner. If anyone has any ideas for hooking up the controls so as to operate everything from the console I'd like that also.
  4. M

    1973 Johnson 135 V-4 tilt/trim

    Is there any way of adding tilt and trim to a 1973 V-4?
  5. M

    Looking for a 2000 40hp 3cyl block

    I recently picked up a 2000 40hp 3cyl and after tearing it down I found the lack of compression in the mid cyl wasn't just a bad ring but was because of a cracked water jacket. Unfortunatly I had already purchased a major rebuild kit. I prefer not having to buy a new one. If anyone has a source...
  6. M

    Mariner console?

    I'm looking to pick up a aluminum center console for my Mariner, unfortunately I didn't measure the original one when I tore out all of the flooring and console. Would someone be able to give me the dimensions of an original wooden one? I'm considering a Sea Ark Alaskan standup console as a...
  7. M

    New project begins

    Well I broke down and picked up a summer project on the 26th of March it is a 73 Starcraft Mariner. Here are some pics of the initial tearout. I currently have all the floor, front deck and the foam removed. My plan is to run aluminum channel across each rib and redeck with .100 5052 aluminum. I...
See more
Top