Hi, whenever I turn the flywheel by hand, the motor makes a strange noise. It is a 1982 80 hp mariner. 4 cylinder, 2 carbs. I have been told this is the compression leaking from the motor. Is this correct? Any info will help, thanks
Hi i have been fixing up an old 1977 bass boat and the gel coat is a little rough in a few places. Trying to get some tips and advice ( materials, techniques, ect ) before stating. I would appreciate it! - mason
Hi, I was hoping to get some ideas from a few people about my mariner. When I bought it, I was told it didn't run and had ignition problems. I managed to fix the ignition problems and got it to run. But it runs very rough. At idle the motor shakes pretty bad, and it seems to rev up and down...
Ive been working on the carbs on a mariner (cleaned and rebuilt them) and it still runs the same. Idles rough, shakes, and not much power WOT. I havent had the engine timing adjusted. Could this be the cause of the problem? Thanks- mason
I just cleaned the carbs on this mariner and put new needles and seats in the carbs. Ialso adjusted the floats to the proper height. It stay running just fine but it seems to rev up and down slightly. I havent had the chance to take it out on the water yet
Hi i just got this 83' 80 hp mariner running and on the muffs i noticed it was running bad. I ran some sea foam through it and tested it on the water and no difference. It stalled most of the time when put in gear and in WOT the rpms seemed to jump from high to low but it still keep me going...
I just fixed the ignition on this mariner and but a new fuel line on it. We tested it on the water for the first time and it ran but would not go into gear without stalling. It would only run with the fast idle engaged. I have tested it for spark and it has spark on all 4 cylinders. Im assuming...
I recently fixed the ignition on my motor and i tried to start it and the flywheel barely turns. I took the plugs out and then tried it and it turned fine so the starter motors not bad. Im stumped. Any suggestions?
Thanks- mason
I bought my boat as a project and have just recently made progress on the motor. I had a grounding issue with the starter solinoid but re-wired the solinoid and fixed the grounding problem. When i first fired the motor i noticed the motor would crank but would only turn the flywheel very slow. I...