I'm in process of building a garage. I would like to know what size garage door would be needed to fit a 24' Pontoon boat in? It has a collapsible Aluminum hard top. I think an 8' high x 10' wide would do the trick, but I'm open to suggestions. I'm trying to steer clear of double width doors. I...
I have a 9.9 long shaft. The cooling tube is bent. I cut it off and I'm gonna try a compression brass fitting to extend the length of the tube to fit in the water pump. I just don't know how long it should be past the extension housing.
Anyone able to help?
Thanks
Just picked up a 77 85 hp Johnson...no controls. Putting it on a pontoon that has a 9.9 evinrude with controls. The controls only operate the shift and throttle. The 85 has electric choke and tach output. Do I just need to run a couple of wires for this? The motor has a red plug for the wiring...
Re: No spark issue 125 hp force (1988)
I need to wire it at the motor. The deck is so shot I'm not safe to step on it to get under the dash for a wire.
I bought this bayliner with a force 125hp motor, said it ran...years ago, I can't get it to turn over with the key. I'm using a remote start switch wired to the solenoid. I only have the main battery wires hooked up. Is there somewhere I need to run a hot wire to give the ignition power?
I got this 9.9 (1977) and it had low compression on 1 cylinder. Put a new head on it and it seems fine. 110 top 105 lower. I started it up and let it run for about an hour in a barrel, in gear. I checked the tep at the head and it showed 141F. Everything seemed fine. I shut it off and left for a...
Just got a 1988 Force 125 that runs, but the prop doesn't turn. Previous owner said it was running and made a snapping/whirring noise and the prop stopped. The motor still ran but the prop no longer worked. I haven't got into it yet, but I was wondering if someone could point me in the right...
My motor (1973 115 Evinrude) sounded great, and performed well and all of the sudden I heard this groan. I shut it down and used the trolling motor to get in. I pulled the drain plug and got a little water and a little oil and 1 small metal fragment on the magnet. I filled it with oil and ran it...
I picked up this 40 hp motor for a song and got it running with very little effort. I had it out Friday and it ran great. It pushed my old Alumacraft 15' to 22 mph according to the fish finder. So today I talked the wife and kids in to going to the lake for the 4th of July. Of course the motor...
Got the motor wired up and control cables hooked up. Sunday morning I fired it up on the muffs. :D The motor was still missing some, :confused: but I think it was flooding at the bottom carb. I shut everything off and checked it out, fired it back up, and proceeded to find out that the overheat...
I bought this boat last year and recently found out that all the wood in the boat is junk. Time for a rebuild. I called around and to replace the transom alone was $900-$1500. I can't afford that so, it's into the boat rebuild arena I go. I'm going to try to keepa a log of what is going on.
I had a battery go bad on my boat (1973 Winner w/ 115 Evinrude) I killed it trying to start the motor. I accidentally hooked the pos (+) cable on the neg(-) battery post and as I touched the neg (-) cable to the pos (+) post I saw a spark. I pulled the cables off and switched them around and...
I'm looking for a used Navonics East map chip that is compatible with a Humminbird 787c2. (SD card format) I know they offer a trade in value when upgrading, so I was hoping to pick one up for somewhere close to that. EDIT
Thanks