Does anyone know where I can get a electric fuel pump (the one inside the vapor separator) for a 2000 mercury 200 hp EFI? Mercury parts express wants to sell me the whole banana for $900. I just need the electric pump....... Are they really this high?
I have 2000 200HP EFI with a 20" shaft, and need it to be a 25" leg/midsection. I have seen 5" adapters for the 25 to 30 (xl to xxl). Can this be done for the 20"?? Also can the exhaust tube from the 20" work on the 25" (or exh tubes only sized by HP not length).<br /><br />The lower foot...
Has anyone ever counter rotated a motor themselves????? I am thinking all I need is a starter, maybe a trigger plate, and lower unit gears. Am I leaving anything out? Any help would great... Does anyone know what the factory charges for counter rotating. :confused:
Does anyone have a good ballpark number, that my water pressure guage should be reading under power. At best, I am seeing 12 lbs. I put a new impeller in recently and it still seems low. The tell tail water seems ok but when I run this CC wide open, I get an alarm. The boat is a 92'...
On my Fountain CC, it has a notched transom, and the cavitation plate on the motor is<br />approximately 3 inches above the keel line. From the rear, looking down the keel line, my prop<br />has about 80% below the keel line. Is this acceptable????? Does the notched transom allow<br />more...
cyl 1=106 <br />cyl 2=103<br />cyl 3=116<br />cyl 4=121<br />cyl 5=116<br />cyl 6=126<br />........1992 Mercury 200 hp. Motor has about 50 hours on it.
I have a 84' Merc 275 hp(3.4 liter) that has some aftermarket reeds and would to know where I could get more. As a last resort, I will buy Mercury Marines. Someone please help.
Can anyone out there tell why I am burning pistons. I have a carb'd 92' mercury 200 with extra long shaft. The motor has less than 50 total hours on it. I bought it with no compression in #1 and #2. When I tore into it, I found that the piston tops were melting away. I replaced pistons 1...
Does anyone out there know why I keep burning up pistons. I have a motor with less than 50 total hours on it and I have put 2(number one and 2)pistons in it and after 15 hours of double-oil breakin, number 3 seems to be melting away at the top edge. I have not even showered down on this motor...
