The first 4 pictures are of a funtional navigation light and bezel from a Larson Thunderhawk. Not mine but I wish it was.
The 5 picture is of my non functional navigation light with no bezel.
When I was sent these pictures the first thing I thought was I have seen this bezel before but it was...
Does anyone have an idea how far forward a motor can be moved until the pontoons create enough turbulence to affect the power? Or is there?
Pontoon deck is 8' center to center of toons 6' length short
Does anyone have any info on a old boat add on accessory you mounted on the lower part on the transom that deverts water to give you Rooster tails when moving.
I have only heard them called Rooster Tails but cannot find anything on them.
Can someone explain the difference between the two?
(General Purpose Resin
An orthophthalic general purpose polyester laminating resin which exhibits a moderate exotherm temperature and cure to allow for thicker laminate applications.
Available in Waxed IP-150 or Unwaxed - IP140 Sizes 1...
Good day to all
I will be running twin 58 Evinrude 35hp electric start/choke motors on a boat which quite cappable of doing.
The problem with running twins is everthing has to be twins.
I am trying to eliminate as much unneeded weight as possible and thought about the batteries.
The only...
I looking to purchase a good vacuum for cleanup of everything from fiberglass dust to rotten wood scrapings.
I have been using donated household and small wet dry units but it don't take long before I am taking it out to the garbage.
I would even consider a nice wall mount if possible.
Any...
Good day
I am looking for some feed back on using a pour in composite as a replacement to using wood on a lap line hull.
I have only seen it used on one boat but then again I havent gone out of my way to look for it until now.
I tried to post some pictures of my boat but it keeps comeing...
I have just finished stripping off all the shinny accesories and just got a few screws holding the rub rail from falling to the ground before the serious stuff happens.
The rub rail is in not bad condition considering it's 54 years old but I will admit it is a bit hard.
Is there something that...
Good day
I have a couple of 1957 35hp Evinrudes model #25930
I will be stripping them down to rebuild.
Are there any tricks or modifications that could be made to this model which would maximize the performance one could expect from this motor verses a stock condition.
I will be up dateing...
I am looking for some idea's or suggestions on a way of adding a remote steer to cable steer system.
I have the type of cable steering where the cables runs down both sides of the boat.
It would be nice to have this unit about half way down the boat mounted on the gunnel.
It would make...
Good day
I would like to add a remote steering mounted on the gunnel which is a cable steer system.
It sure would make life easier when trolling not to have to keep reaching for the steering wheel.
Any ideas or pictures or both.
Good day to all
I have been seaching for a vintaged engine control to run twin motors with zero luck.
This has brought me to the point where I am considering just stacking a set side by side but without trying I know I would have to bend the handels to allow them to operate properly. Or I...
I am looking for a Canadian bussiness that specializes in resto's of vintaged Johnson or Evinrude motors.
Can anyone recomend a shop.
Shipping anything North will cost more in Taxes than the actual cost.