I've got 2 batteries wired in with my add a battery kit from blue sea systems and the system works great.
Recently, I added and onboard charger to maintain the batteries while away. protournament 100 by promariner. The charger works as advertised but with the add a battery kit installed the ACR...
took the boat out on the water today after replacing a torn fuel pump diaphram. Got up to 2000 rpm and wouldn't go any further. thought maybe a clogged fuel filter, changed it and didn't work.
got home kinda pissed played ps3 for a lil to cool off. then went back out to look at it.
found t2...
I had to replace my fuel pump diaphram this past weekend. I'm wondering what would cause it to rip? could it be that the fuel filter putting a strain on the diaphram? bad parts? pumping primer bulb to much? bad parts?
Im asking because it hasn't been very long since i changed it out.
I haven't been able to locate a lifting ring for my 1988 85hp force. All refer me to the type that screws into the center of the flywheel. Which is not correct for the type i have. Crowleymarine shows a part number for one but is no longer manufactured.
does anyone have one? would rather...
Recently overhauled my carbs. I noticed when i took the carbs off the floats were hanging down past the high speed jet. so it definitely needed adjusting. I replaced the springs, needle and cleaned the carbs.
I now have my float height adjusted parallel to the carb body. and idle mixture and...
Has anyone had any experience with these rebuilt units from crowley marine. I'm considering purchasing one to replace my aging 85hp.
Been researching different companies but found some reviews that made me steer away from them.
so what about crowley marine?
I'm looking to overhaul my carbs upon inspection I found that all 3 idle needles had worn in grooves at the tips. Manual says to replace if grooves are present so parts are on order.
would worn idle needles cause the problems that i was having like.
1. sometimes when i start the motor it...
Just wondering if anyone has used this setup for 2 batteries. How did you like it? here's the link. http://www.ezacdc.com/Scripts/prodView.asp?idproduct=155
I went to anchor my boat today, dropped the anchor, and put it in reverse. Gave it a little throttle and the motor tilted up out of the water.
I dont think this is normal. Is there a lock mechanism of some kind that keeps it from doing this? what does it look like? the motor is an 85hp...
Just recently acquired a 17ft center console fishing boat with the force 85.
I know nothing about boats. This is my first boat. It didn't come with any manuals. They guy i bought it from said it ran fine but i dont always trust sellers.
1. can you recommend a good service manual? (clymer...
hello,
First of all I would like to begin by saying thank god I found a forum like this. I'm considering purchasing a project boat. its a 1986 searay with non working mercruiser 140.
I went too look at it today, well this is what i found just by looking at it. I'm no boat guru.
*rotted...