Intermediate Mariner
Petty Officer 2nd Class
- Joined
- Apr 24, 2010
- Messages
- 190
Hello today,
Surely someone has seen this. I am working on a 1962 'rude 40 hp M#35530 carburetor.
There is a slow speed needle that was pretty grooved out. I seen you should replace them if they are ground down and not a sharp point.
I also had seen that you should replace the seat inside but I either can't get it out or there isn't one. I removed a series of washers and a piece with threads. It looks like there is more in there but it's either stuck or I'm missing something.
Any ideas?
Thanks a million-
Shawn T
Wichita, KS
Surely someone has seen this. I am working on a 1962 'rude 40 hp M#35530 carburetor.
There is a slow speed needle that was pretty grooved out. I seen you should replace them if they are ground down and not a sharp point.
I also had seen that you should replace the seat inside but I either can't get it out or there isn't one. I removed a series of washers and a piece with threads. It looks like there is more in there but it's either stuck or I'm missing something.
Any ideas?
Thanks a million-
Shawn T
Wichita, KS