Re: VRO Oil Hose Replacement
Cool dmd.After lengthing and connecting the replacemet hose, leave it disconnected at the inlet of the vro pump and squeeze the reservoir primer bulb until you have solid air free oil weeping out.Might want to place the hose end into a container to perform this or it can get messy.Then connect to vro inlet.Mix oil at 50:1 in your fuel tank.Mark a line on the side of the oil reservoir exactly at the oil level line visible through plastic tank.Run engine at 50:1 premix until you can confirm oil usage from reservoir.This will keep you from possibly smoking the engine from no lubrication.May even get a no oil alarm a couple of times when initially testing after replacement.Once any air that may be in the line from replacement works through,alarms should clear.Just make sure you verify oil usage before just using straight fuel in fuel tank.Good luck.