dohcdelsol93
Petty Officer 3rd Class
- Joined
- Jul 13, 2010
- Messages
- 97
So i got my outdrive off. Looking at my leak free rams there is an issue with one of them. The starboard side is pitted badly. I can see half the threads of the one of the high pressure inlet hoses. I need a replacement. I think its wise to deal with this in the midst of a transom rebuild and not later when i would have to remove the engine again to remove the locking pins.
Im sitting on some 4 sets of mercury cylinders but these square tubes that fit from about 84 to 91 290/290a both sp and dp connect under the gimball housing and outdrive, not outside. They are also much shorter thab the mercury. Is there a good supplier of an aftermarket ram or supplier of a good used one, even if it's just a good body I can use my inner parts along with new seals/o rings.
Thanks ahead of time
Im sitting on some 4 sets of mercury cylinders but these square tubes that fit from about 84 to 91 290/290a both sp and dp connect under the gimball housing and outdrive, not outside. They are also much shorter thab the mercury. Is there a good supplier of an aftermarket ram or supplier of a good used one, even if it's just a good body I can use my inner parts along with new seals/o rings.
Thanks ahead of time