racezilla500
Cadet
- Joined
- Jul 4, 2011
- Messages
- 16
1988 Mariner 90 hp 3 cylinder.
The power tilt/trim stopped working after being on the water for a few hours today.
I'm using the rocker switch on my throttle arm. Not sure if there is another switch anywhere else.
No clicking, humming, or anything else. Just dead. I used the relief screw to raise it up enough to put my support arm in.
Can anyone help a rookie out? I'm frantically searching the site for answers.
Thanks for any advice!
The power tilt/trim stopped working after being on the water for a few hours today.
I'm using the rocker switch on my throttle arm. Not sure if there is another switch anywhere else.
No clicking, humming, or anything else. Just dead. I used the relief screw to raise it up enough to put my support arm in.
Can anyone help a rookie out? I'm frantically searching the site for answers.
Thanks for any advice!