BarryK3
Seaman Apprentice
- Joined
- Dec 6, 2017
- Messages
- 48
Hi all,
I recently bought a Bayliner Capri 1800 with manual tilt and I am going to install a used hydraulic tilt/trim unit.
Can someone please post a picture or describe where to connect the red power and black ground leads from the solenoids to the engine? I understand how to connect the green and blue leads. There are already green and blue wires in the harness going from the engine to the dashboard area.
Also, what parts of the manual tilt need to be removed? There is a sliding arm on the starboard side, a sliding arm with lock (for full tilt) on port side. There is a latch in the center to lock motor to the cross bar.
Thanks in advance!
Barry
I recently bought a Bayliner Capri 1800 with manual tilt and I am going to install a used hydraulic tilt/trim unit.
Can someone please post a picture or describe where to connect the red power and black ground leads from the solenoids to the engine? I understand how to connect the green and blue leads. There are already green and blue wires in the harness going from the engine to the dashboard area.
Also, what parts of the manual tilt need to be removed? There is a sliding arm on the starboard side, a sliding arm with lock (for full tilt) on port side. There is a latch in the center to lock motor to the cross bar.
Thanks in advance!
Barry