More troubleshooting questions (pic attached)

[tlocus73]

I'm checking around and found out that the yellow & yellow-grey wires coming from the stator and timer base have continuity. I isolated these wires from the Regulator by unscrewing them on the terminal block. Is this continuity ok?

Btw, the Regulator side of these wires (isolated from stator) do not have continuity.

 

[multimech]

Re: More troubleshooting questions (pic attached)

Yes the continuity is fine. They come from the same coil of wire. They produce an AC current which is fed to the rectifier which chops off part of the sine wave and turns this into DC (direct) current. Then is then regulated to produce the constant charging volts.

Do you have a problem with charging?