I have a 1984 Mercuriser 140. The control handle is one that you pull out from the side/wall to neutral for starting. It has trim up/down button on the shift handle and tilt/trailer on the wall.
Just today the up portion of the trim on the shift handle stopped working, never a problem.
So, I had to use the trailer/tilt button to get proper angle for hole shot/cruising etc.
Is there a general set of priority steps or areas to check that are known to cause this problem, and is it likely a biggie, a short, a fuse, a loose wire,,,,or ????
Thanks for any help or ideas.
Just today the up portion of the trim on the shift handle stopped working, never a problem.
So, I had to use the trailer/tilt button to get proper angle for hole shot/cruising etc.
Is there a general set of priority steps or areas to check that are known to cause this problem, and is it likely a biggie, a short, a fuse, a loose wire,,,,or ????
Thanks for any help or ideas.