The wires coming from the trim switch; the purple one is plugged in; we have a left over blue wire that we are not sure where it goes. the trim switch runs it down fine, but it will not run it up. with trailer switch and without. when you push the trailer switch it just clicks to raise it. if i cross the wires on the switch, it does the same so it appears the switch is fine. on the top solenoid if i cross the two large post with a screw driver it runs it up fine.
The mercathode on the side of the motor appears to be all hooked up right with the mercruiser manual.
Any thoughts / suggestions would be helpful.
(88 Baja w/ 454)
The mercathode on the side of the motor appears to be all hooked up right with the mercruiser manual.
Any thoughts / suggestions would be helpful.
(88 Baja w/ 454)