affliction14
Recruit
- Joined
- May 16, 2012
- Messages
- 1
I am having power tilt and trim problems with the relays. I am getting power comming from the wire that goes to the tilt and trim motor but when I hook the relay it just clicks and the motor doesent move. I had the relays tested and they were good. Does anybody have any info that could help me. I even bought new plugs for the relays. The guy at the store told me that normaly the middle wire doesent get used on my 5 five prong relay. If anyone has a right diagram I would greatly appreaciate your help.
The relay is five prong the center prong is 87a than if you look at the front of the relay with the screw hole to the back the front pin is 87 the one to the right is 85 the one in the back is 30 than the one on the right is 86. The diagraam on the relay has 85 on top of the rectangle and 86 under it than it has a dotted line with 87a on top with a diaonagle line going down to the thirty and the 87 is on top next to the 87a with a circle and a tiny line going down.
So can anyone please help me since you can tell I dont know nothing about relays and how they work. Thank you.
The relay is five prong the center prong is 87a than if you look at the front of the relay with the screw hole to the back the front pin is 87 the one to the right is 85 the one in the back is 30 than the one on the right is 86. The diagraam on the relay has 85 on top of the rectangle and 86 under it than it has a dotted line with 87a on top with a diaonagle line going down to the thirty and the 87 is on top next to the 87a with a circle and a tiny line going down.
So can anyone please help me since you can tell I dont know nothing about relays and how they work. Thank you.